Sagetalk becomes read only March 31, 2009

By Wayne Schulz • February 26th, 2009

A posting on the Sage Online Support Service has spelled out the official fate of Sage’s old discussion forum known as Sagetalk.

Effective on March 31, 2009 all messages in Sagetalk will be set to read only status. No new postings will be accepted and new user registration will likely stop.

Sagetalk has been replaced by the new Sage MAS90 Community Forums which are much easier to navigate and allow for reading of new messages without any login.

One of the easiest ways to read new messages in the Sage Community is via the use of RSS feeds which are small one or two line summaries of the messages posted to the forum.

An explanation of RSS feeds and how to setup a feed so that you can read the new Sage Community support forums via RSS is available here.

It’s important to note that Sage intends to keep the prior Sagetalk messages around for the immediate future so they can be used as reference for older technical topics.

  • Share/Bookmark

This website uses IntenseDebate comments, but they are not currently loaded because either your browser doesn't support JavaScript, or they didn't load fast enough.

Comments

Trackbacks

 

Leave a Comment

You must be logged in to post a comment.

« | Home | »